RGB Indoor Standard Density LED Strip Light — 12V, 3W/ft, IP20

Description

Part of our Contractor Series, this standard-density 12V RGB LED strip delivers versatile color-changing light for accent, backlighting, shelving, displays, and decorative indoor applications. The flexible IP20 strip includes 3M adhesive backing for easy installation and is available in custom lengths.

Need a waterproof version? View the RGB Waterproof Standard Density LED Strip Light.

RGB Configuration

RGB Color Control

An RGB controller is required to independently control the red, green, and blue channels. Compatible controllers allow you to mix colors, adjust brightness, and create dynamic color-changing effects.

Lengths & Cutting

Available in 3 ft, 6 ft, 9 ft, 12 ft, and full 16.4 ft (5m) roll lengths. The strip can also be cut every 4 inches at the marked copper cut points.

Installation & Connections

RGB strip sections can be connected with compatible 4-pin solderless connectors or by soldering multi-conductor wire between sections. The maximum continuous run is 32.8 ft; longer installations should use additional power feeds or be wired in parallel to minimize voltage drop.

Power & Control

A 12V DC power supply and compatible RGB controller are required. Use the Power by Length table below when sizing the power supply for each continuous strip run.

Power by Length

Important: Power draw is not linear over longer strip runs. Voltage drop along the strip reduces the actual wattage as the run gets longer, so a full 16.4 ft (5m) roll draws approximately 27W rather than the amount calculated by multiplying the short-length watts-per-foot value across the entire roll. Use the values above when sizing a power supply for a continuous run.

Need Help with LED Strips?

Guide to LED Strip Lights

Setting Up Color Changing LED Strips

Full Documentation

Documentation