QuadPuck - 4 Channel DMX Constant Current Controller
|On-Board selectable DMX addressing||DMX transmission error indicators|
|One to four control channel capability||Loop-through for DMX & power|
|Interchangeable BuckPuck capability||Selectable POST tests (Power-On-Self-Test)|
|Channel activity indicators (LED)||Optional terminal blocks for power & outputs|
|USITT DMX/512/1990 Compatible||Small size (4? x 2.5? x 1?)|
|Simple RJ45 connections for DMX & power||Powering & controlling High-Power LED arrays|
The LuxDrive 4016 series QuadPuck DMX driver interface offers the ultimate in flexibility and compatibility for controlling high-brightness LEDs. Up to (4) BuckPuck LED power modules can be individually controlled using a standard USITT DMX/512/1990 controller, providing a simple, low cost solution for powering and controlling LEDs, all in one compact unit.
The QuadPuck DMX Driver Interface is available with a number of options and features, providing even greater flexibility, and is small enough to be easily incorporated in LED lighting units, placed in wall-mount boxes, or in remotely located units.
|Input Voltage||8-32 VDC|
|Input Current (control section)||20-30 mA|
|Input Current (power section)||Up to 4.5A|
|Output Current (per ch.) .||140-1100mA|
|Max. LED Count (total)||72 1-Watt LEDs|
|PWM Step Size||6.4µs|
|Data Termination||110 , Jumper Selectable|
|Mounting||(4) 0.156"dia holes|
|Input Voltage||8-32 VDC|
|Input Current (Power)||Up to 4.5A|
|Output Current (per CH.)||140-1100 mA|
|LED Count (Max.)||72 Luxeon I LEDs|
Configuration: The QuadPuck is configured with three BCD switches. Switches should only be changed with the power off, except in the case of the two test modes 90x and 99x where SW1 can be changed with power applied. Configuration parameters are loaded into memory only at power-on. Each time a configuration parameter is changed and power is re-applied, the error and power lights flash quickly three times to signify that the new parameters have been permanently stored within the device. Invalid switch settings cause the error indicator to flash twice slowly and then the device uses the internally stored last-used parameters. The factory device defaults are set to DMX address 1 (one), fade rate 3 (three) and no Power-On Self Test (POST).
Note: The above are product highlights and not the complete manufacturers datasheet. Please view the .pdf for complete specifications.
01/30/2014 - 09:52:55 PM
Products You May Like
The A019 & F019 dimmer series from LUXdrive™ use a turn knob or vertical slider control and wall mounting plate for 0-10V dimming.
Product ID : 0x019
Sale Price: $24.99
This 12V amplifier is designed to simplify dimming loads larger than 72-watts by repeating the signal to 3 output channels each capable of 6A loads.
Product ID : LS-3R-6A
Sale Price: $34.99
Single color PWM LED dimmer with radio frequency remote used for wireless dimming of 12Vdc LED strip lighting.
Product ID : DIMMER-1CH-12A
Sale Price: $8.99