0-10V Wall Mount Dimming Control
|0-10V Current Sinking Dimmer||Dims multiple units with ease!|
|Design Options: Turn-style knob or Vertical Slider||Wall mounting face plate included!|
|Reverse Polarity Protection||Logarithmic Response|
|Easy Installation!||Hardware included: Wire nuts & mounting screws|
LUXdrive's 0-10 volt DC low-voltage dimming control is made to dim high power LEDs.This dimmer was designed to work wtih LuxDrive drivers but will be compatible with all drivers with a 0-10V control. The dimmer comes in two different designs: a rotary knob or a vertical slider, the choice is yours! Added features include fast logarithmic response and reverse polarity protection.
What is included?
- Dimming Control
- Face Plate for wall mounting
- Mounting Screws
- Wire Nuts
LUXdrive made this low voltage dimmer to work with their low voltage driver lines and high power LED strips. This 0-10V dimmer will control the products listed below from 0-100% brightness. Also listed are the maximum amount of units that can be dimmed from a single dimmer.
Low Voltage Driver
A009 BuckBlock & A011 FlexBlock - maximum 25 units
3021/3023 BuckPuck & 4015 BoostPuck - maximum 4 units
High Power LED Strips
6014 Elara Strip, 9008 LuxStrip II & A006 LuxStrip II - maximum 50 strips
See the data sheet below for specific wiring instructions but most compatible drivers with a current sinking control will have the same color wires. Gray is the control line and purple is the reference line. Connect the two like wires together and you will be good to go!
What if the drivers have a 3rd wire?
Current sourcing drivers have a 3rd line that is the reference voltage line. In these setups the wire is usually yellow and you will be wondering what to do since there are only two wires coming off the dimmer. All you need to do is attach this extra wire and the purple wire from the driver to the purple wire on the dimmer. Connect the gray lines together like normal and you will be all set!
01/30/2014 - 09:49:17 PM
01/20/2014 - 04:37:30 PM