PWM 12V LED Amplifier (Repeater)

Description

The LS-3R-6A (designed for use with PWM Dimmer LS-PWM-6A) is a Pulse Width Modulated (PWM) repeater or LED amplifier for dimming larger than 72-Watt runs of LEDs from one dimmer.

The LED repeater can handle 12V-24Vdc input upto 210-watts and comes with two separate input connections should you need it. The output of the repeater has 3-channels, each capable of a 6 amp (6A) load.  Finally the the last connection is from the repeater to the dimmer. See figure 1 to the right for more details on connections.

Technical Documentation

Installation Instructions

WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC). Install in a well-ventilated area free from explosive gases and vapors.  Proper operation requires the free flow of air.

• BE SURE THAT REPEATER IS IS DISCONNECTED AT THE SOURCE BEFORE PROCEEDING!
• DO NOT OPEN THE REPEATER OR ATTEMPT TO SERVICE - THIS COULD CREATE A SHOCK HAZARD AND/OR DAMAGE THE DEVICE!
• DO NOT CONNECT 120V AC POWER TO THIS DEVICE. IT MUST BE POWERED ONLY BY 12V OR 24V DC (CONSTANT VOLTAGE) POWER.
• For all wire-to-wire connections, use UL Listed wire nuts.
• Do not exceed 6 amps of load per channel.

Full Documentation & Installation Instructions